Hi
Just recently got this BMW after many years after having an old Mk2 Escort that slowly fell apart over 20 years. So still getting to know it. My issue is after leaving the car into the garage to replace the front discs and pads, on driving back noticed the brakepad wear light on the dashboard was on. So I just thought I'd replace the sensors however there aren't any sensors that I can see or indeed anywhere to plug a sensor in. I know I can just ignore but want to fix it.
Anything I'm missing / any help greatly appreciated.
Thanks Sean
Brakepad Wear Sesnor
- Jeroen
- Site Admin
- Posts: 30125
- Joined: Tue Sep 14, 2004 12:23 pm
- My E21(s): '81 323i Baur
- Location: The Netherlands
- Contact:
Re: Brakepad Wear Sesnor
If you have rear drums you only have a wear sensor at the left front wheel, connector is at the strut
Regards/groeten, Jeroen
Re: Brakepad Wear Sesnor
I seem to remember the light can also come on with low fluid level, the sensor in the reservoir.
1982 323i ("Test Mule" - to become an M20 powered track car)
1983 316 (Taiga Thunder - S54 Track car)
1982 635csiA (Another Weldathon)
2004 330d Touring (The Daily Hack / Tow Car / Load lugger)
1974 3.0 csi (The first Weldathon)
1983 316 (Taiga Thunder - S54 Track car)
1982 635csiA (Another Weldathon)
2004 330d Touring (The Daily Hack / Tow Car / Load lugger)
1974 3.0 csi (The first Weldathon)
Re: Brakepad Wear Sesnor
anche se lo indicatore nella ruota anteriore sinistra non è collegato
